The cleaning steps of Kailun En pre filter usually include the following key steps to ensure the effective operation of the filter and extend its service life: 1. Preparation stage
1. Turn off the water source and power supply: Ensure that the inlet valve is closed and disconnect the power supply (if the filter is electric) to avoid accidents during the cleaning process.
2. Disassemble the filter: Based on the specific model and structure of the filter, disassemble the main part of the filter, remove the filter bottle, filter element, and other components. Please handle with care during the disassembly process to avoid damaging the filter. 2、 Cleaning stage
1. Preliminary cleaning: Rinse the filter bottle, filter element and other components with clean water to remove surface dust and impurities.
2. Deep cleaning: - Use cleaning agent: If there is stubborn dirt on the filter element, neutral detergent or diluted cleaning agent can be used for cleaning. Pay attention to selecting the appropriate cleaning agent for the pre filter and dilute it according to the ratio in the instruction manual- Soaking and Brushing: Soak the filter element and other components in the cleaning solution for a period of time (the specific time depends on the cleaning agent manual), and then gently brush the surface of the filter element with a soft bristled brush or sponge to remove deep dirt.
3. Rinse and air dry: Rinse the filter element and filter bottle repeatedly with clean water until there is no residue of cleaning agent. Then air dry them or wipe them dry with a clean cloth to ensure that both the inside and outside are completely dry. 3、 Inspection and assembly
1. Check components: Before assembly, carefully inspect all components for damage or wear. If necessary, replace damaged components in a timely manner.
2. Reassemble: reassemble the filter element, filter bottle, and other components onto the filter host in the reverse order of disassembly. Make sure the connection is tight and there is no water leakage.
3. Test run: After assembly is complete, open the inlet valve and power (if applicable) to allow the filter to undergo a brief run test. Observe whether there is any water leakage or other abnormal situation. 4、 Precautions
1. Safety first: During the cleaning process, attention should be paid to personal safety to avoid accidents such as electric shock or slipping.
2. Follow the instructions: During the cleaning and assembly process, be sure to follow the user manual and cleaning guide of the filter to ensure correct operation.
3. Regular cleaning: It is recommended to regularly clean the pre filter based on water quality and usage. Usually, cleaning once every 3-6 months is sufficient, but in cases of poor water quality or high usage frequency, the cleaning frequency should be appropriately increased.
4. Replacing the filter element: The filter element is the core component of the pre filter, and its filtration effect and service life directly affect water quality. It is recommended to regularly replace the filter element to ensure the continuous stability of water quality. The specific replacement cycle can be determined based on the model and usage of the filter element.