The installation process of polar routing is relatively simple and can be mainly divided into the following steps: 1. Preparation work
1. Prepare equipment: Make sure you have a router, computer (or phone/tablet), and Ethernet cable (which may require two depending on your network environment) at hand.
2. Refer to the instruction manual: Carefully read the user manual of the router to understand its interface, default login address, default password, and other basic information. 2、 Connect devices
1. Connecting broadband: - If your broadband is telephone line access (ADSL), you need to use an Ethernet cable to connect the LAN port of the broadband modem to the WAN port of the polar router- If your broadband is fiber optic access, directly connect the LAN port of the optical modem to the WAN port of the polar router using a network cable- If the home network cable is directly connected, also connect the network cable to the WAN port of the polar router.
2. Connect computer: Use another Ethernet cable to connect the computer's Ethernet port to any LAN port of the polar router. If using a wireless device (such as a phone or tablet) for setup, this step is not required, but it is necessary to first ensure that the device is connected to the WiFi of the router (WiFi may not be encrypted initially). 3、 Log in to the router management interface
1. Open the browser: Enter the default login address of the router in the address bar of the computer's browser, usually 'hiwifi. com' or '192, 168, 199, 1', and then press Enter.
2. Enter password: In the pop-up login interface, enter the default management password for the router (this password can usually be found on the user manual or the nameplate on the surface of the router). After the first login, it is recommended to change the default password to increase security. 4、 Set up router
1. Set internet access method: Based on your broadband type (such as broadband dial-up, automatic IP address acquisition, static IP, etc.), select the corresponding internet access method in the router management interface and fill in the corresponding internet access parameters (such as broadband account, password, etc.).
2. Set WiFi: In the router management interface, set your WiFi name (SSID) and password. It is recommended to use complex and difficult to guess passwords to improve the security of WiFi networks.
3. Other settings: You can also make other settings as needed, such as changing the router's login password, enabling/disabling wireless broadcasting, setting MAC address filtering, etc. 5、 Check if the settings are successful
After completing the above settings, log in to the router management interface again and check if all settings have been correctly saved and taken effect. At the same time, you can try connecting to your WiFi network using a computer or wireless device to check if you can access the internet normally. matters needing attention
-When setting up the router, please ensure that your computer or wireless device is connected to the router's network.
-If you are using a wireless device for setup, please ensure that the WiFi function of the device is turned on and connected to the router's WiFi network.
-When changing the default password, please make sure to remember the new password to avoid being unable to log in to the router management interface in the future.
-If you encounter any problems during the setup process, please refer to the user manual of the polar router or contact customer service for assistance.